Replacement Procedures
4.7 Keyboard
Removing the keyboard
The following describes the procedure for removing the keyboard (See Figure 4-8 to 4-9).
CAUTION: As the keycap may fall out, when handling the keyboard always hold it by
the frame and do not touch the keycap.
1. Turn the computer upside down
2. Loose the screw securing KBD Holder.
M2.0x1.8B Flat BIND screws x3
3. Upside down the computer.
4. Remove KBD holder. Remove the KB holder screw: M2.5 x 3B x1
5. Insert your finger into the keyboard slot and keyboard. Then lift up the keyboard to
remove it.
6. Disconnect keyboard cable.
Satellite A300 Maintenance Manual(960-Q08) 4-21
To Next Page
Loading...
