Replacement Procedures
4.10 Cover assembly
Removing the cover assembly
The following describes the procedure for removing the cover assembly (See Figure 4-19 to
4-21).
1. Turn over the computer.
2. Remove the following screws securing the cover assembly from the back and bottom
of computer.
• M2.0×8.0 FLAT BIND screw Back x9
• M2.5×4.5 FLAT BIND screw Back x9
Figure 4-19 removing the screws (back)
3. Disconnect the touch pad flat cable/Fingerprint cable/Bluetooth Cable from the
connector on the system board.
Satellite A300 Maintenance Manual(960-Q08)
4-29
To Next Page
Loading...
