Toshiba Satellite A300 Series - Wake-up on LAN Feature; Built-in LAN Functions; LED ON;OFF Settings

Replacement Procedures
4.14 CPU
Removing the CPU heat sink
The following describes the procedure for removing the CPU heat sink (See Figure 4-27).
1. Disconnect the MB from the connector on the system board
Disconnect VGA from the connector
2. Remove the following screws securing the heat sink holder and remove the thermal
module
• M2.5×5.0 BIND screw x2
• M2.5x 3.0 BIND screw x4
NOTE: When removing the heat sink holder, be sure to remove the screws in the reverse
order of the number marked on the holder.
3. Remove the CPU heat sink.
Figure 4-27 Removing the CPU heat sink
Satellite A300 Maintenance Manual(960-Q08)
39