4 Replacement Procedures 4.2 HDD
4. Remove the HDD pack by pulling on the tab attached to the pack, following the
direction of the arrows.
NOTE: Do not disassemble the HDD pack when it is working normally. Disassemble
or replace the HDD pack only if it fails.
5. Place the HDD pack on a flat surface (such as a desk), and remove the four M3x3.5
black flat head screws.
6. Place the HDD pack on a flat surface (such as a desk), and remove the chassis.
M3x black flat head screw-3.5
Main HDD chassis
Main HDD
M3x black flat head screw-3.5
Figure 4-8 Removing the HDD chassis
CAUTION: Do not apply pressure to the top or bottom of the drive.
4-16 Satellite M200/M205 / Satellite Pro M200/ EQUIUM M200/ SATEGO M200 Maintenance Manual
To Next Page
Loading...
