4 Replacement Procedures 4.8 Speakers
4.8 Speakers
Removing the Speakers
Remove the Speakers according to the following procedures and Figure 4-20.
1. Disconnect the speaker cable from CN2.
2. Remove one M2.5x3 white flat head screw securing the left speaker.
3. Remove one M2.5x3 white flat head screw securing the right speaker.
4. Remove the left and right speakers.
CN2
M2 5x3 white flat screw.
Figure 4-20 Removing the speakers
Installing the Speakers
Install the speakers according to the following procedures and Figure 4-20.
1. Seat the left and right speaker in the correct position.
2. Route the speaker cable in the wire guide.
3. Secure the left speaker with one M2.5x3 white flat head screw.
4. Secure the right speaker with one M2.5x3 white flat head screws.
5. Connect the left speaker and right speaker cables to CN2 on the system board.
4-32 Satellite A300/Satellite Pro A300/EQUIUM A300/SATEGO A300 Maintenance Manual
To Next Page
Loading...
