4.10 Display Assembly 4 Replacement Procedures
4.10 Display Assembly
Removing the Display Assembly
CAUTION: Use care to avoid that the antenna cable is not caught between the display
assembly and computer.
Remove the display assembly according to the following procedures and Figures 4-22.
1. Disconnect the LCD/FL cable from CN6, Microphone cable connector from CN10
and Camera cable connector from CN5 on the system board.
2. Remove four M2.5x3.5 white flat head screws securing the LCD module to the top
cover.
3. Remove the wireless antenna cables from the top cover.
4. Remove the display module.
CAUTION: LCM module hinge cannot be disassembled.
M2 5x3 5 white flat screw..
CN6
CN10
CN5
Figure 4-22 Removing the display assembly
Satellite A300/Satellite Pro A300/EQUIUM A300/SATEGO A300 Maintenance Manual 4-35
To Next Page
Loading...
