4.18 CCD Board and MIC 4 Replacement Procedures
4.18 CCD Board and MIC
Removing the CCD Board and MIC
Remove the FL inverter board according to the following procedures and Figure 4-38.
1. Disconnect the CCD cable from the CCD module connector and remove the CCD
board.
CCD board
MIC
CCD board cable
Figure 4-38 Removing the CCD board and MIC
2. Lift the MIC from the display rear cover.
Satellite A300/Satellite Pro A300/EQUIUM A300/SATEGO A300 Maintenance Manual 4-59
To Next Page
Loading...
