3.2 Executing the Diagnostic Test 3 Tests and Diagnostics
Satellite A40 Maintenance Manual (960-458) 3-7
5. The following message will appear:
ERROR STOP : YES/NO
Selecting YES stops the test program when an error is found and displays the operation
guide on the right side of the display screen as shown below:
ERROR STATUS NAME [[ HALT OPERATION ]]
1: Test end
2: Continue
3: Retry
These three selections have the following functions respectively:
[1] Terminates the test program and exits to the subtest menu.
[2] Continues the test.
[3] Restarts the test from the error.
Selecting NO keeps the test running even if an error is found.
Use ↑ or ↓ key to move a cursor of the “TEST LOOP” and “ERROR STOP”
6. Use the arrow keys to move the cursor to the desired option and press Enter.
Table 3-1 in section 3.3 describes the function of each test on the subtest menu. Table 3-2
in section 3.16 describes the error codes and error status for each error.
To Next Page
Loading...
