4 Replacement Procedures 4.14 LED board
4-40 Satellite A40 Maintenance Manual (960-458)
4.14 LED board
Removing the LED board
The following describes the procedure for removing the LED board (See Figure 4-23).
1. Remove the following screw and LED board from the system board.
• M2.5×6B FLAT HEAD screw ×1
2. Disconnect the LED cable from the connector PJ9500 on the system board.
3. Disconnect the LED cable from the LED board.
M2.5
×
6B FLAT HEAD
LED board
LED cable
PJ9500
Figure 4-23 Removing the LED board
To Next Page
Loading...
