4 Replacement Procedures 4.17 System board/ Bat con cover
4-48 Satellite A40 Maintenance Manual (960-458)
Installing the System board/Bat con cover
To install the system board/bat con cover, follow the steps below and refer to figures 4-26 and 27.
1. Install the system board.
NOTE: When installing the system board, be careful not to pinch or damage the fan
cables.
2. Connect the fan cable 2 to the connector PJ8425 on the system board and stick the glass
tape.
3. Connect the fan cable 1 to the connector PJ8450 on the system board and stick the glass
tape.
4. Secure the system board with the following screw.
• M2.5×6B FLAT HEAD screw ×1
5. Install the bat con cover and secure it with the following screw.
• M2.5×6B FLAT HEAD screw ×1
To Next Page
Loading...
