Toshiba Satellite A40 - Page 309

4.26 Fluorescent lamp 4 Replacement Procedure
Satellite A40 Maintenance Manual (960-458) 4-85
Assembling Fluorescent lamp
Putting the double-sided tapes on the bezel
1. Attach the double-sided tape to the reverse side of the bezel, as shown in Figure 4-68.
? ? ? ? ?? ?? ?
? ? ?? ? : 4 5 9 7 ( ? ? 3M )
( ? ? ? ? ? )
±0 .5
285
?? ?? ? ? ? ? ? ? ? ?
? ? ? ? ? ?
?? ?? ? ? ?? ? ?? ? ?
? ? ? ? ? ?
?? ?? ? ? ?? ? ? ? ? ?
?? ? ? ??? ?? ? ? ?
? ?? ? ?? ? ?
( ? ? ? ? )
0
+0 .2
1
? ? 0~ 0. 5 ? ? ? ? ? ? ? ? ? ?
? ??? ? ? ? ?
? ? ?? ?
Reverse side of the bezel
Requirements for attaching
double–sided tape
The end of tape must
not go beyond the
opening of bezel.
Tape must not go
beyond the opening
of the bezel.
Double-sided tape
(4597, Sumitomo 3M)
Attach tape within tolerances from 0.0
to 0.5 from the opening of the bezel.
(
tape width)
(
tape length)
Tapes must not be overlapped.
The end of tape must not
go beyond the opening of
bezel.
Figure 4-68 Replacing 14 Inch TMD fluorescent lamp (6)