Toshiba Satellite A505 - Installing the Top Cover

4.8 Top Cover 4 Replacement Procedures
Hotkey board flat cable
Touch pad
board flat cable
Power cable
M2 5x6 black flat head screw.
Top cover
CN1
CN3
CN12
Figure 4-12 Removing the top cover
Installing the Top Cover
Install the top cover with the display assembly according to the following procedures and
Figures 4-11, 4-12.
1. Seat the top cover, adjusting its position.
2. Secure the top cover with two M2.5x6 black flat-head screws.
3. Connect the touch pad board flat cables to CN12 on the system board.
4. Connect the hotkey board flat cable to CN3 on the system board.
5. Connect the power board cable to CN1 on the system board.
Turn the computer upside down and secure it with the following 21 screws:
- Sixteen M2.5x6 black flat head screws.
- Two M2.5x4 black flat head screws.
- Three M2x4 white flat head screws.
(When use Slot ODD, the middle screw use M2.5 black flat head screw.)
Satellite/Satellite Pro/A500/A505/A507/dynabook Maintenance Manual 4-27