4.13 Display Assembly 4 Replacement Procedures
CN4
CN16
M2 5X3 5 white flat head screw..
CCD cable
MIC cable
LCD FL cable/
Wireless LAN antenna
Figure 4-18 Removing the display assembly
Installing the Display Assembly
Install the display assembly according to the following procedures and Figures 4-17, 4-18.
1. Place the display panel in the correct position and push the wireless antenna cable,
CCD cable and MIC cable into the bottom cover.
2. Connect the CCD cable to CN4 on the system board.
3. Connect the MIC cable to CN16 on the system board.
4. Secure the display assembly with six M2.5x3.5 white flat head screws.
5. Close the display panel and turn the computer so the back is facing you and secure
two M2.5x6 black flat head screws.
Satellite/Satellite Pro/A500/A505/A507/dynabook Maintenance Manual 4-37
To Next Page
Loading...
