Toshiba Satellite A50S Series - Page 317

4.23 Fluorescent Lamp 4 Replacement Procedures
8. Install the bezel (E) on the lamp cover and hook the four latches on the lamp cover and
two latches on the P-chassis.
(E) Bezel
(1) Hitch the hook of the bezel
on the rib of the P-chassis.
<Side view>
Hook
(2) Lean the bezel on the lamp cover without
interference with the TCP.
Figure 4-81 Replacing 15.0 Inch Sharp fluorescent lamp (XGA) (20)
Make sure of mating of the bezel and the rib of the P-chassis.
Make sure of mating the bezel and
the latch of the P-chassis.
Make sure of mating of the bezel
and the latch of the P-chassis.
Figure 4-82 Replacing 15.0 Inch Sharp fluorescent lamp (XGA) (21)
Satellite A50S/TECRA A3X Maintenance Manual (960-534) [CONFIDENTIAL] 4-95