Toshiba Satellite A60 - ODD Bay Modules; Removing the ODD Bay Module

4.6 ODD Bay Module 4 Replacement Procedures
4.6 ODD Bay Modules
Removing the ODD Bay Module
NOTE: The installation and removal procedures are the same for all the modules that
can be installed in the ODD bays. See the appropriate sections for the disassembly
procedures of the specific modules.
Remove the ODD bay module according to the following procedures and Figure 4-16, 4-17.
1. Turn the computer upside down.
2. Remove the M2x8 black bind screw.
3. Turn the computer over and open the display.
4. Push out the ODD bay module in the direction of the arrow.
CAUTION: Handle the ODD bay module carefully, because it becomes hot during
operation.
Figure 4-16 Removing the ODD bay module
Satellite A60/ Pro A60 Maintenance Manual 4-27