4.7 Display Assembly 4 Replacement Procedures
Figure 4-20 Removing the display assembly
Installing the Display Assembly
Install the display assembly according to the following procedures and Figures 4-19, 4-20.
1. Place the display panel in their correct position and push the wireless antenna cable
into the hole.
2. Connect the LCD/FL cable to CN13 on the system board and fix it with one M2x3
white flat-head screw.
3. Securing display assembly with four M2.5x4 black flat-head screws.
4. Close the display panel and turn the computer upside down and fix it with two
M2.5x20 black bind screws.
Satellite A60/ Pro A60 Maintenance Manual 4-31
To Next Page
Loading...
