4 Replacement Procedures 4.13 North Bridge Thermal Module
8. Remove two pieces of sticky mylar securing the MDC cable.
9. Disconnect the MDC cable from CN500 on the system board.
10. Remove the MDC cable.
Figure 4 -31 Removing the North Bridge thermal module
Installing the Removing North Bridge thermal module
Install the Removing North Bridge thermal module according to the following procedures
and Figure 4-30, 4-31.
1. Pleace the MDC cable in the correct position..
2. Connect the MDC cable from CN500 on the system board.
3. Stick two pieces of sticky mylar securing the MDC cable.
4. Connect the North Bridge thermal module cable to the CN15 on the system board.
5. Place the Removing North Bridge thermal module in the correct position.
6. Secure the two washers and M2x3 black bind screws.
7. Place the CD tray in the correct position.
8. Secure one M2.5x2.5 white bind screws.
9. Stick the black sheet in the correct position.
4-46 Satellite A60/ Pro A60 Maintenance Manual
To Next Page
Loading...
