4 Replacement Procedures
4.17 Display Mask
Removing the Display Mask
To remove the display mask, first remove the display assembly as described earlier, then follow
the steps below:
1. Remove the mask seals to expose two lower inner corner screws securing the display mask.
2. Remove two M2.5×5 black screws from the corners that were previously covered by the
mask seals.
3. Carefully insert your fingers between the mask and the LCD panel and pry open the snaps.
Start with the four snaps at the top of the display mask. Continue unsnapping the display
mask along the two sides and the bottom edge to remove display.
Figure 4-28 Removing the display mask
4-42 Satellite A70 Series Maintenance Manual
To Next Page
Loading...
