User’s Manual 7-5
HW Setup and Passwords
LAN
Wake-up on LAN
This feature lets the computer's power be turned on from shutdown when it
receives a wake-up packet (Magic packet) from the LAN.
Power will be automatically turned on when a signal is received from an
administrator's computer which is connected via a network.
The following settings can be changed when the Built-in LAN is Enabled.
Connect the AC adaptor when using the Wake-up on LAN function. The
battery retention time will be shorter than the times listed in this manual
when this function is enabled. Refer to the section in chapter 6, Retaining
Data with Power off.
Built-in LAN
This feature enables or disables the Built-in LAN.
Do not install or remove a memory module while Wake-up on LAN is
enabled.
■ The Wake-up on LAN function consumes power even when the
system is off. Leave the AC adaptor connected while using this
feature.
■ Regarding Wake-up on LAN from sleep or hibernation, you must check
the "
Allow the device to wake the computer" check
box within the LAN Device properties. (This feafure does not effect the
Wake-up on LAN from sleep or hibernation.)
Enabled
Enables Wake-up on LAN from shutdown.
Disabled
Disables Wake-up on LAN from shutdown.
(Default)
Enabled
Enables built-in LAN functions. (Default)
Disabled
Disables built-in LAN functions.
To Next Page
Loading...
