User’s Manual 3-17
Hardware, Utilities and Options
6. Slide your fingernail or a thin object under the cover and lift it off.
Figure 3-4 Removing the memory module cover
7. Align the notch of the memory module with that of the memory slot and
gently insert the module into the slot at about a 30 degree angle before
holding it down until the latches on either side snap into place.
Figure 3-5 Seating the memory module-1
Use a point size 0 Phillips screwdriver.
1. Memory module cover
2. Screw
1. Slot A
2. Slot B
1
2
1
2
To Next Page
Loading...
