38
Moving the computer
5.375 x 8.375 ver 3.1
Removing a disc with the computer on
To remove a compact disc (CD or DVD) with the computer
turned on:
1 Press the eject button on the drive.
Do not press the eject button while the in-use indicator light is
glowing. Doing so could damage the disc or the drive.
Also, if the disc is still spinning when you open the disc tray, wait for
it to stop spinning before you remove it.
2 Pull the tray out until it is fully open, remove the disc,
and place it in its protective cover.
3 Gently press the tray in to close it.
Removing a disc with the computer off
To remove a disc with the computer turned off:
1 Insert a slender object, such as a straightened paper clip,
into the manual eject hole.
The disc tray slides partially out of the drive (about 1 inch).
Never use a pencil to press the manual eject button. Pencil lead can
break off inside the computer and damage it.
2 Pull the tray out until it is fully open, remove the disc,
and place it in its protective cover.
3 Gently press the tray in to close it.
Moving the computer
Before moving your computer, even across the room, make
sure all disk activity has ended (the drive indicator light stops
glowing) and all external peripheral cables are disconnected.
Do not pick up the computer by its display panel or by the back
(where the ports are located). Doing so could damage the system.
PMA500334012.book Page 38 Tuesday, August 15, 2006 9:24 AM
To Next Page
Loading...
