25
Adding memory (optional)
5.375 x 8.375 ver 3.1
To avoid damaging the computer’s screws, use a small Phillips
screwdriver that is in good condition.
Installing a memory module with the computer’s power on may
damage the computer, the module, or both.
The computer has two memory slots—Slot A and Slot B. You can
install one or two memory modules.
Before you install or remove a memory module, turn off the computer
using the Start menu. If you install or remove a memory module
while the computer is in Sleep or Hibernation mode, data will be lost.
For this model Slot A is the bottom slot. Slot B is the top slot.If only one
memory module is to be installed, it must be installed in slot A.
If the computer is on, begin at step 1; otherwise, skip to step 3.
1 Click Start, and then click the arrow next to the lock button in
the lower-right corner of the Start menu.
The Shut Down menu appears.
(Sample Image) Shut Down menu
2 Click Shut Down.
The operating system turns off the computer.
3 Unplug and remove any cables connected to the computer,
including the AC adaptor.
4 Remove the main battery. For information on removing the
main battery, see “Removing the battery from the computer”
on page 38.
Shut Down Menu
Start
Arrow
To Next Page
Loading...
