4.3 Memory Module 4 Replacement Procedures
4.3 Memory Module
Removing the Memory Module
Remove the memory module according to the following procedures and Figures 4-3, after
checking that the computer is turned off in boot mode.
CAUTION: Remove the optional memory after turning off the computer. If this is
violated, the computer or memory can be damaged.
1. Turn the computer upside down.
2. Release one memory module cover securing the screw.
3. Remove the memory module cover.
CAUTION: Do not touch the connectors on the memory modules or in the computer.
Contaminated connectors can cause memory access problems.
Memory cover screw
Memory cover
Memory
Latches
Figure 4-3 Removing the memory module
4. Spread out the two memory lock latches so that the memory module pops up.
5. Pull the memory module up and out at an angle, using care to avoid touching the
connectors.
Satellite/Satellite Pro/L630/L635 Maintenance Manual 4-11
To Next Page
Loading...
