4 Replacement Procedures 4.6 ODD Bay Module
Disassembling the ODD Drive
NOTE: Do not disassemble the ODD drive when it is working normally. Disassemble
or replace the ODD drive only if it fails.
Disassemble the ODD drive according to the following procedures and Figure 4-8.
1. Remove two M2x3 black flat head screws.
2. Remove the bracket.
ODD bay module
M2x3 black
flat head screw
Figure 4-8 Removing the bracket from the ODD drive
Assembling the ODD Drive
Assemble the ODD drive according to the following procedures and Figure 4-8.
1. Seat the bracket and secure it with two M2x3 black flat head screws.
4-20 Satellite/Satellite Pro/L650 Maintenance Manual
To Next Page
Loading...
