User’s Manual 4-22
Operating Basics
2. Before recording the video to Video DVD or Blu-ray disc:
■ When you record Video DVD or Blu-ray disc, please use only discs
recommended by the Drive manufacturer.
■ Do not set the working drive to a slow device like a USB1.1 hard
disk drive or it will fail to write Video DVD or Blu-ray disc.
■ Do not perform any of the following actions:
■ Operate the computer for any other function, including using a
mouse or Touch Pad, or closing/opening the display panel.
■ Bump or cause vibration to the computer.
■ Use the Mode control button and Audio/Video control button to
reproduce music or voice.
■ Open the DVD/BD drive.
■ Install, remove or connect external devices, including the
following: SD/SDHC/SDXC memory card, USB device, external
display, and optical digital devices.
■ Please verify your disc after recording important data.
■ DVD+R/+RW disc cannot be written in VR format.
■ There is no support to output VCD and SVCD formats.
3. About recorded DVDs and Blu-ray discs:
■ When playing your recorded DVD-Video/VR on your computer,
please use the DVD playback application.
■ When playing your recorded Blu-ray Disc on your computer, please
use the Corel WinDVD BD for TOSHIBA.
■ If you use an over-used rewritable disc, the full formatting might be
locked. Please use a brand new disc.
■ Some DVD drives for personal computers or other DVD players may
not be able to read DVD-R/+R/-RW/+RW/-RAM discs.
■ Some BD drives for personal computers or other Blu-ray disc
players may not be able to read BD-R/RE discs.
TOSHIBA DVD PLAYER
Please be aware of the following limitations when you use the TOSHIBA
DVD PLAYER:
Notes on use
■ TOSHIBA DVD PLAYER is only preinstalled on Windows 7 Starter
and Home Basic Operation Systems.
■ "TOSHIBA DVD PLAYER" software is supported for playback of
DVD-Video and DVD-VR.
■ Frame dropping, audio skipping or out of sync audio and video may
occur during playback of some DVD-Video titles.
To Next Page
Loading...
