Replacement Procedures
Satellite P100 Maintenance Manual (960-Q02) 4-15
Installing a HDD
The following describes the procedure for installing a HDD (See Figure 4-3 to 4-4).
1. Install a HDD to the HDD holder and secure it with the following screws.
• M3.0×3.5F FLAT BIND screw x4
NOTE: Although they are 3mm head screws, screw torque must be set in 2.5kg-cm for
four screws securing the HDD holder.
2. Insert the HDD assembly into the HDD slot and connect it carefully to the CN19 on
the system board.
3. Secure the HDD assembly with the following screw.
• M2.5×4.0B FLAT BIND screw x2
To Next Page
Loading...
