Replacement Procedures
Satellite P100 Maintenance Manual (960-Q02) 4-23
Installing the keyboard
The following describes the procedure for installing the keyboard (See Figure 4-8 to 4-9).
1. Turn the keyboard upside down and place it on the palm rest as its face down.
Connect the keyboard flexible cable to the connector CN3200 on the system board.
2. Slide and set the speaker cover assembly and secure it with the following screw.
• M2.5×3.0B FLAT BIND screw x6
3. Install the keyboard brace by pressing it from the topside.
To Next Page
Loading...
