Replacement Procedures
Satellite P100 Maintenance Manual (960-Q02) 4-41
4.15 Fingerprint
The following describes for removing the cover assembly (See Figure 4-24).
Remove the Fingerprint
1. Pull out the fingerprint cable from connect CN5
2. Loose below screws from fingerprint board and take it out top case
z M2.5x4.0 FLAT BIND screw x2
Figure 4-24 Removing the Fingerprint
Installing the Fingerprint
1. Turn over top case and put fingerprint in correct location
2. Fix below screws and connect the fingerprint cable CN5
z M2.5x4.0 FLAT BIND screw x2
M2.5x4.0
To Next Page
Loading...
