Replacement Procedures
4-54 Satellite P100 Maintenance Manual (960-Q02)
8. Remove the following screws securing the LCD unit.
• M2.5x4.0 BINK HEAD screw x6
9. With the bottom edge of the LCD unit on the display cover, lift only the top edge of
the LCD unit. After peeling off the CONDUTIVE tape, disconnect the LCD harness
from the connector on the back of the LCD.
10. Remove the LCD unit.
Figure 4-33 Removing the LCD unit
M2.5x4.0 BINK HEAD
CONDUTIVE tape
LCD harness
LCD unit
M2.5X4.0 BINK HEAD
To Next Page
Loading...
