4.24 Fan and CPU 4 Replacement Procedures
4.24 Fan and CPU
Removing the Fan and CPU
To remove the fan, heat sink, and CPU, you must first remove the display assembly, keyboard,
top cover and system board, and then follow the steps below:
1. Turn the system board upside down. Remove the six M2.5x3 screws from the heat sink.
Follow the order indicated by the numbers on the heat sink in reverse to remove the
screws.
Figure 4-70 Removing the heat sink screws
2. Lift and remove the heat sink from the system board.
Figure 4-71 Removing the heat sink
Satellite P200
/ P205
Series Maintenance Manual
[CONFIDENTIAL]
4-59
To Next Page
Loading...
