Toshiba Satellite P205D - Page 151

4.5 HDD 4 Replacement Procedures
4. Pull out the black Mylar tab to remove the HDD unit.
Figure 4-15 Removing the secondary HDD
5. Pull the HDD outwards and remove the four silver M3x3 screws that secure the HDD
case and brackets to the HDD.
6. Remove the HDD from the HDD case.
Installing the Main HDD
To install the main HDD, follow these steps and refer to the figures in the preceding section.
1. Seat the main HDD in the HDD case and brackets, and secure it with four silver M3×3
screws.
2. Insert the main HDD unit into the HDD slot on the left.
3. Secure the HDD door with one black M2.5x4 screw.
Installing the Secondary HDD
To install the secondary HDD, follow these steps and refer to the figures in the preceding
section.
1. Seat the secondary HDD in the HDD case and brackets, and secure it with four silver
M3×3 screws.
2. Insert the secondary HDD unit into the HDD slot on the right.
3. Secure the HDD door with two black M2.5x4 screws.
Satellite P200D/P205D Series Maintenance Manual [CONFIDENTIAL] 4-17