4 Replacement Procedures 4.12 Function Button Board
4.12 Function Button Board
Removing the Function Button Board
The function button board is located on the back side of the strip cover. First remove the
button panel from the top chassis as described in the previous section. Then follow the steps
below:
1. Turn the strip cover over.
2. Remove the M2.5x4 screw securing the function button board to the strip cover.
Figure 4-35 Removing the function button board screw
3. Slide out the function button board in direction of the arrow.
Figure 4-36 Sliding out the function button board
4. Lift the function button board up.
Figure 4-37 Removing the function button board
4-34
[CONFIDENTIAL]
Satellite P200D/P205D Series Maintenance Manual
To Next Page
Loading...
