4 Replacement Procedures 4.17 Fingerprint Module
4.17 Fingerprint Module
Removing the Fingerprint Module
To remove the Fingerprint Module, first remove the battery pack, keyboard, and top cover,
and then follow the steps below:
1. Remove four M2.5x3 screws securing the Fingerprint Module Bracket to the rear side of
the top cover.
Figure 4-49 Removing the fingerprint module bracket screws
2. Remove the bracket.
Figure 4-50 Removing the fingerprint module bracket
4-44
[CONFIDENTIAL]
Satellite P200D/P205D Series Maintenance Manual
To Next Page
Loading...
