4.26 FL Inverter Board 4 Replacement Procedures
4.26 FL Inverter Board
Removing the FL Inverter Board
To remove the FL inverter board, first remove the battery pack, the display assembly, display
mask, and LCD module, then follow the steps below:
1. Remove the black M2x4 screw securing the FL inverter board to the top chassis.
Figure 4-79 Removing the FL inverter board screws
2. Disconnect the two connectors on either side of the FL inverter board.
Figure 4-80 Removing the connectors
Satellite P200D/P205D Series Maintenance Manual
[CONFIDENTIAL]
4-65
To Next Page
Loading...
