27
Setting up your computer and getting started
RG 5.375 x 8.375 ver 2.3.3
Base of the computer
5 Using a standard Phillips no. 1 screwdriver, unscrew the
two screws that secure the memory slot cover, then
remove the memory slot cover.
Removing the memory slot cover screws
6 Place the screws and the cover in a safe place so that you
can retrieve them later.
Static electricity can damage the memory module. Before you handle
the module, touch a grounded metal surface to discharge any static
electricity you may have built up.
To avoid damaging the memory module, be careful not to touch its
gold connector bar (on the side you insert into the computer).
7 Remove the new memory module from its antistatic
packaging.
8 Holding the memory module by its edges so that the gold
connector bar faces the slot, fit the module into the
socket.
9 Gently press down on the memory module connector
until the clips snap into place.
Expansion
memory
slot cover
To Next Page
Loading...
