Replacement Procedures
4.11 Cover assembly
Removing the cover assembly
The following describes the procedure for removing the cover assembly (See Figure 4-11-1
to 4-11-3).
1. Turn over the computer.
2. Remove the following screws securing the cover assembly from the back and bottom
of computer.
• M2.5×2.0 FLAT BIND screw Back x5
• M2.5×6.5 FLAT BIND screw Back x11
• M2.5×8.0 FLAT BIND screw Back x6
• M2.5×4.0 FLAT BIND screw Back x3
Figure 4-11-1 Remove the screws (back)
Satellite P500 and Satellite Pro500 Maintenance Manual (960-Q08)
4-3
To Next Page
Loading...
