3. Lay the dis c, la be l s ide up, in the dis c tray.
Figure 4-7 Inse rting a dis c
1
1. Las er le ns
Whe n the disc tra y is fully ope ne d, the e dge of the compute r will cove r the
dis c tray s lightly. The re fore , you will ne e d to turn the dis c a t a n a ngle whe n
you pla ce it in the disc tray. Afte r s e ating the disc, however, ma ke s ure it
lie s fla t.
Do not touch the la ser lens or a ny portion of its s urrounding ca sing a s
this could caus e mis a lignme nt.
Prevent fore ign obje cts from e nte ring the drive . Che ck the s urfa ce of
the dis c tra y, e spe cia lly the a re a be hind the front e dge of the dis c tra y,
to ma ke sure the re a re no s uch obje cts before clos ing the drive .
4. Press ge ntly a t the cente r of the disc until you fe e l it click into pla ce .
The dis c s hould lie be low the top of the s pindle , flush with the s pindle
ba s e .
5. Pus h the ce nte r of the dis c tra y to clos e it. Press gently until it locks
into place .
If the dis c is not s e a ted prope rly when the dis c tra y is clos e d, the dis c might
be damage d. Als o, the dis c tra y might not ope n fully whe n you pre s s the
eject button.
Re m o v in g d is c s
To re move the dis c, follow the s te ps a s de tailed below:
Do not pre s s the e ject button while the compute r is a ccess ing the optica l
dis c drive. Wa it for the optical dis c drive indica tor to go out before you ope n
the disc tra y. Als o, if the dis c is s pinning when you ope n the disc tra y, wait
for it to stop before you re move it.
1. To pop the dis c tray partially ope n, press the e ject button. Ge ntly pull
the dis c tra y out until it is fully ope ned.
Use r's Ma nua l 4-13
To Next Page
Loading...
