Do not touch the connectors on the memory module or on the
computer. Debris on the connectors might cause memory access
problems.
Figure 4-14 Removing the memory module
1. Latches
Product appearance depends on the model you purchased.
9. Seat the memory module cover in place and secure it with the screw.
Ensure that the memory module cover is firmly closed.
10. Install the battery pack.
11. Turn your computer over.
12. Connect the AC adaptor and turn the computer on.
LAN
The computer has built-in support for Ethernet LAN (10 megabits per
second, 10BASE-T), Fast Ethernet LAN (100 megabits per second,
100BASE-TX) or Gigabit Ethernet LAN (1000 megabits per second,
1000BASE-T).
This section describes how to connect/disconnect to a LAN.
The Wake-up on LAN function consumes power even when the
system is off. Leave the AC adaptor connected while using this
feature.
The Link speed (10/100/1000 megabits per second) changes
automatically depending on the network conditions (connected device,
cable or noise and so on).
User's Manual 4-32
To Next Page
Loading...
