Toshiba Satellite U300 Series - Wireless LAN Card

Replacement Procedures
4.5 Wireless LAN card
Removing a Wireless LAN card
The following describes the procedure for removing a Wireless LAN card (See Figure 4-5).
1. Remove the following screw of wireless cover securing wireless LAN card cover
and remove it. And remove screw of wireless board
• 2.5.0 x 4.0B BIND screw x4
2. Disconnect the wireless LAN antenna cable from the connectors on a wireless LAN
card.
3. Open the left and right latches holding a wireless LAN card and remove a wireless
LAN card from the connector on the system board.
Wireless LAN card cover with
4 screws
Wireless LAN card
CN30
Wireless LAN with 2 screws
Wireless LAN antenna
cable
4-16Satellite U300 and Satellite Pro U300 Maintenance Manual (960-Q08)