Replacement Procedures
4.10 Cover assembly
Removing the cover assembly
The following describes the procedure for removing the cover assembly (See Figure 4-19 to
4-21).
1. Turn over the computer.
2. Remove the following screws securing the cover assembly from the back and bottom
of computer.
• M2.0×5.0 FLAT BIND screw Back x5
• M2.5×10 FLAT BIND screw Back x2
• M2.0×4.0 FLAT BIND screw Back x1
• M2.5×7.0B FLAT BIND screw Back x6
• M2.0x3.0 FLAT BIND screw Back x4
4-34
Satellite U300 and Satellite Pro U300 Maintenance Manual (960-Q08)
To Next Page
Loading...
