Replacement Procedures
Screw 2.0*2.5
ODD bracket
Figure 4-13 Disassemble the side bracket
Installing optical disk drive
The following describes the procedure of installing an optical disk drive.
1. Attach the ODD bracket to an optical disk drive and secure it with the following
screws.
• M2.0×2.5 Flat BIND screw x2
2. Insert an optical disk drive assembly into the slot and connect it to the connector on
the system board.
3. Secure the ODD drive with the following screw.
M2.0X5.0 Flat BIND screw x1
Satellite U400/Satellite Pro U400/PORTEGE M800
Maintenance Manual 4-26
To Next Page
Loading...
