4 Replacement Procedures
3. Remove the following screws securing HDD module.
• M2×3L FLAT HEAD screw ×4
4. Pull the tab of the HDD assembly to remove it from the connector of the HDD
cable. Be careful not to damage the connector.
Figure 4-5 Removing the HDD assembly
NOTE: The following steps describe how to disassemble the HDD assembly, however, do
not disassemble if the HDD is working properly.
5. Place the HDD assembly on a flat surface, and remove the following screws.
• M3×4L FLAT HEAD screw ×4
6. Separate the HDD and HDD bracket.
Satellite/Satellite Pro U500/U500D, PORTEGE M900/M900D Maintenance Manual 4-19
To Next Page
Loading...
