Error! No text of specified style in document. Error! No text of specified style in document. 4
Replacement Procedures
[CONFIDENTIAL] Metis 10F/10FG Maintenance Manual 4-19
4.6 WLAN Card
Removing the WLAN Card
Remove the WLAN card according to the following procedures and Figure 4-9.
1. Disconnect the two antenna cables from the WLAN card.
2. Remove the two M2×3 screws securing the WLAN card, the WLAN card pops up
automatically.
3. Remove the WLAN card at an angle of 45 degree.
Figure 4-9 Removing the WLAN Card
Installing the WLAN Card
Install the WLAN card according to the following procedures:
1. Insert the WLAN card into the connector on the motherboard at an angle of 45 degree.
2. Press the WLAN card down and secure it with two M2×3 screws.
To Next Page
Loading...
