4 Replacement Procedures Error! No text of specified style in document. Error! No text of
specified style in document.
4-26 Metis 10F/10FG Maintenance Manual [CONFIDENTIAL]
Figure 4-13 Removing the Touchpad
Installing the Touchpad
Install the Touchpad according to the following procedures:
1. Seat the touchpad in the logic upper assembly, press down the touchpad to make sure
three hooks locked the touchpad module.
2. Secure the two M2.5×4 screws.
3. Connect the LED board FFC to touchpad board.
To Next Page
Loading...
