1-4
Disc cannot be read.
No
Yes
No
Yes
No
Yes
Yes
No
Yes
Disc cannot be read.
Check the loaded circuit
1.Check voltage on pin 100 of U1
varies between 0 and 3.3V:
Æ3.3V for CD
Æ0V for DVD
2.Check whether peripheral
components are eroded or defect
Check the FFC connection
between 24P and the loader.
Check U1 and peripheral
components
Re-solder or replace the defective
parts
Check the connection
between U1 and loader
Correct connection
Replace U1 or loader.
Yes
Check whether there is laser
voltage (2.3V for DVD and 1.9V
for CD) on Collector of Q2 &Q3
Check if there is RFO signal on
pin10 of CN2. (The normal RFO
signal is a clear reticulated wave)
Check U1, U7, and peripheral
components are eroded or
badly soldered.
Trouble shooting chart
No
To Next Page
Loading...
