Toshiba SD-220EB - Page 83

1-2-3. Output PC Board
1. Eject the tray slightly.
2. Peel off the tape (1).
3. Remove the connector (2) and the flexible cable (3).
4. Remove two screws (4), then remove the output-RGB
PC board (5).
Note:
• Wind the wire around the connector (6) several times
when mounting the connector (2).
Fig. 2-1-9
Tape (1)
Output RGB PC board (5)
Screws (4)
Connector (2)
Connector (6)
Connector (2)
Wind the wire
several times.
Flexible
cable (3)
Tray
Connector (6)
Eject the tray slightly.
1-2-4. Front PC Board (SD-220)
1. Remove the front panel. (Refer to item 1-1-3.)
2. Remove eight screws (1), then remove the front
display PC board (2).
3. Remove the flexible cable (3).
4. Remove three screws (4), then remove the ENTER
switch (5).
Fig. 2-1-10
1-2-5. Front PC Board (SD-120)
1. Remove the front panel. (Refer to item 1-1-3.)
2. Remove eight screws (1), then remove the front
display PC board (2).
Fig. 2-1-11
ENTER
Switch(5)
Flexible
cable (3)
Front display
PC board (2)
Screws (1)
Screws (4)
Front display
PC board (2)
Screws (1)