1-3. Mechanism Parts
1-3-1. Mechanism Chassis Assembly
Note:
• When removing the mechanism chassis assembly (3),
be sure to short-circuit the laser diode output land
before removing the connector and the flexible cables.
After replacing, open the land as it was after inserting
the connector and flexible cables.
1. Remove the front panel. (Refer to item 1-1-3.)
2. Remove three flexible cables (1).
3. Remove four screws (2), then remove the mechanism
chassis assembly (3).
Fig. 2-1-12
Pickup head
Laser diode
output lands
Screws (2)
Flexible
Cable (1)
Mechanism
chassis assembly (3)
To Next Page
Loading...
