Connecting to an Audio System
You can listen to the sound of audio CDs and DVD video discs in stereo.
To audio inputs
Audio system
To VIDEO OUT To AUDIO OUT (L/R)
S-video cable (Not supplied)
To S-VIDEO OUT
To video input
To S-video input
TV or monitor with
audio/video inputs
Audio cable
(supplied)
Video cable
(supplied)
❍
Refer to the owner’s manual of your audio system as well.
❍
Before you connect the DVD player to other equipment, be sure to turn off the power and unplug all of the equipment from the
wall outlet before making any connections.
❍
If you place the DVD player near a tuner or radio, the radio broadcast sound might be distorted. In this case, move the DVD
player away from the tuner and radio.
❍
The output sound of the DVD player has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate
listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.
❍
Turn off the receiver before you connect or disconnect the DVD player’s power cord. If you leave the receiver power on, the
speakers may be damaged.
Warning
Do not set the Digital Audio Output of this DVD player to “Dolby Digital” unless you are connecting the DIGITAL OUT jack of this DVD
player to an AV decoder that has the Dolby Digital decoding function. High volume sound may damage your hearing as well as the
speakers (Refer to “Selecting Digital Audio Output” on page 38).
Notes
If the TV has an S-video input, connect
the DVD player with the S-video cable.
Connecting to a TV
Connect the DVD player to your TV.
S-video cable
(Not supplied)
To S-VIDEO OUT
To COMPONENT
VIDEO OUT
To AUDIO OUT (L/R)/
VIDEO OUT
VIDEO OUTPUT SELECT switch
Audio/Video cable
(supplied)
To video input
To audio inputs
Video cable (Y, Pb, Pr)
(not supplied)
To S-video input
TV or monitor with
audio/video inputs
❍
Refer to the owner’s manual of your TV as well.
❍
Before you connect the DVD player to your TV, be sure to turn off the power and unplug both units from the wall outlet before
making any connections.
❍
Connect the DVD player to your TV directly. If you connect the DVD player to a VCR, the playback picture will be distorted
because DVD video discs are copy protected.
Warning
Do not set the Digital Audio Output of this DVD player to “Dolby Digital” unless you are connecting the DIGITAL OUT jack of this
DVD player to an AV decoder that has the Dolby Digital decoding function. High volume sound may damage your hearing as well
as the speakers (Refer to “Selecting Digital Audio Output” on page 38).
Notes
If the TV has an S-video input, connect
the DVD player with the S-video cable.
When using COMPONENT VIDEO OUT jack, set the VIDEO
OUTPUT switch to COMPONENT or when using S-VIDEO
OUT jack, set the VIDEO OUTPUT switch to S-VIDEO.
PAGE 12 CONNECTIONS
To Next Page
Loading...
