!ii:ii!_!!ii;i_i__,_!i!;_ii!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!ii_i!_i!
Note: The S-video output and component video output transports the DVD-video signal exclusively and will deliver
enhanced DVD video picture performance,
_[-_ I _ ) AUDIOOUT r_ ]_
----n
I t_ _ \ _ I / When you makethis connection,set theS-VIDEO/
TOwall outlet COMPONENT Video selector switchtothe desired
_ToS- I ToP_JC_ ToP8/Cd ToY _lloutlet_ / osiion
)UT I )UT OUT OUT [ __e _orres_on_irg _(eo
/ / / Component video Audio cable (not supplied)
• cable (not supplied) • ,
TOaudio Inputs of 4i _
& _i;_- _:_/_ the amplifier_'_
[ | "I_To Y video inpu_._ [_ fred) _ (white)
/ [ "__ToPB/C8video input [_1" _1_ ,'o =_===__O1'_ ] ",
/ ToP,,oRvideoinput.. H
t TOS'vide° inpu_ U_ _ (_) _(_
S-video cable (not supplied) TV or monitor with Audio system
If you connect the DVD/VCR to your TV Co Iorstream®
with the DVD OUT jacks, select the component video inputs
corresponding video input on your
television to watch DVD video discs.
Component video (ColorStream ®)outputs/inputs
Some TVs or monitors are equipped with component video inputs. Connecting to these inputsallows you to enjoy the
highest quality DVD picture playback.
Actual labels for component video inputs may vary depending on the TV manufacturer. (ex. Y, R-Y, B-Y or Y,Ca, CR)
In some TVs or monitors, the color levels of the playback picture may be reduced slightly or the tint may change. In
such a case, adjust the TV or monitor for optimum performance.
0
Notes:
• Refer to the owner's manual of the connected equipment as well.
• When you connect the DVD/VCR to other equipment, be sure to turn off the power and unplug all of the equipment from the
wall outlet before making any connections.
• If you place the DVD/VCR near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the DVD/
VCR away from the tuner and radio.
• The output sound of the DVD/VCR has a wide dynamic range. Be sure to adjust the receiver's volume to a moderate listening
level. Otherwise, the speakers may be damaged by a sudden high volume sound.
• Turn off the amplifier before you connect or disconnect the DVD/VCR's power cord. If you leave the amplifier power on, the
speakers may be damaged.
• An S-Video connection is superior to Video (Yellow) output. Use this method for DVD playback when the connected television
has S-Video input, and does not have component video inputs.
To Next Page
Loading...
