34
The Drive gives me a “Device cannot start. Code (10).”
A: This is a power issue. Make sure your connections are secure.
The other possibility is that the Drive has malfunctioned and
requires service.
I don’t see my Toshiba Drive in My Computer, but it does
appear in Device Manager.
A: Right-click on My Computer. Select Manage in the pop-up menu.
In the Computer Management window, select Storage, then select
Disk Management. In the Disk Management window, you should see
a list of available storage devices. Look for the disk that has a capacity
closest to your Toshiba Drive. Right-click on the right-hand box; in
the pop-up menu select Delete Partition. Once you do this, it will say
“Online” & “Unallocated.” Right-click on the box and select Create New
Partition in the pop-up menu. When the Partition Wizard appears,
select Primary Partition and click on Next. You will see a default value
for the Toshiba Drive; click Next. You will then see a Drive letter (you
can change this Drive letter if you wish); click Next. You will then be
asked to format the Toshiba Drive.
When I try to format my Drive I get the message: “Could not
complete format.”
A: This problem can occur if you are using an expansion card to
connect the Toshiba Drive. Plug the Drive into a data port on your
To Next Page
Loading...
